MOISTRON ™
Sensore di umidità a microonde
GeneralitÀ
- Range di umidità
- Il sensore può misurare fino alla saturazione del materiale
- Condizioni operative
-
- Temperatura (Oper.): 0°C / 85°C
- Temperatura (Stor.): -55°C / +155°C
- Umidità (moisture): 0% / 100%.
- Contenitore
-
- Acciaio inox AISI-316;
- Grado di protezione (DIN 40 050): IC IP 67.
- Accoppiamento: ceramica
- Anello di chiusura: acciaio temperato
- Dimensioni
-
- Diametro esterno: 75 mm
- Lunghezza: 120 mm
Electrical Specifications:
- Power Supply
- 24V ac / dc ±10%
Protection Earth available.
Power Consumption:3W max.
- Analog Output
-
Selectable between:
- 4-20mA: 3-wire connection topology; 750 Ω max measurement resistor ±0,1% resolution.
- 0-5V / 0-10V: 10k max connectable load; ±0,1% resolution
- Digital Output
-
- Activated with programmable threshold on measured moisture
- NPN output
- 30Vmax output level; 200mA max output current.
- Fused against overcurrents.
- Max drop voltage: 1V (@ 200mA output current)
- Serial Interfaces
Selectable between:
- RS-232:
- Selectable baud rate (1200, 2400, 4800, 9600 and 19600 baud);
- Asynchronous serial protocol studied for each moisture measurement application.
- RS-485:
- Selectable baud-rate (1200, 2400, 4800, 9600 and 19600 baud).
- Protection diodes against voltage surges between different point of RS-485 network.
- 120 Ohm termination resistor if required
- Pull-up and pull-down resistor for proper serial lines biasing in idle mode (if required).
- Network addressing available for multi-point measurements.
- Asynchronous serial protocol defined for each moisture measurement application
- External connectors
-
- J1: Standard M12 4 poles plug:
- Pole 1: Protection Earth
- Pole 2: + 24Vdc (or 24V ac)
- Pole 3: -24Vdc (or 24V ac)
- Pole 4: Not Used.
- J2: Standard M2 4 poles plug
Digital/Analog and (Serial Interfaces) outputs choices:
- Pole 1: GND (GND)
- Pole 2: Digital out-NPN (RX)
- Pole 3: Digital out-V/A (TX)
- Pole 4: Not used (Not-used)